Center Console
Covered
console. I just bought some vinyl and went to it. You have to
remove the panel UNDERNEATH by removing all the screws. Then you'll
have easy access for revoering. If your console padding is still
moderately good, you can give the top a shave. My Dad had previously
cut off the thrashed top half of the console lid with a bandsaw,
for example, then painted it with a flat black several times,
and this gave it a good surface for putting on the new vinyl.
If your console padding
is considerably worn, like down to the plastic, you can chose
to rip all the foam off the center console and start from scratch.
To do this, remove the lid, remove all the screws from the bottom
of the lid, and remove the inside panel. Then, use a razor blade
to trace just outside the area of the foam that is FUSED into
the plastic. Them remove the foam and recover as you wish.